Braking Sensor/Switch: Adjustments
Brake Pedal and Brake Pedal Position Switch AdjustmentPedal Height
1. Turn the brake pedal position switch (A) counterclockwise, and pull it back until it is no longer touching the brake pedal.
2. Lift up the carpet. At the insulator cutout, measure the pedal height (B) from the left side middle of the pedal pad (C).
Standard pedal height (with carpet removed):
M/T model: 171 mm (6 3/4 in.)
A/T model: 170 mm (6 11/16 in.)
3. Loosen the pushrod locknut (A), and screw the pushrod (B) in or out with pliers until the standard pedal height from the floor is reached. After adjustment, tighten the locknut firmly. Do not adjust the pedal height with the pushrod pressed.
Brake Pedal Position Switch Clearance
4. Pull up on the brake pedal, then push in the brake pedal position switch until its plunger is fully pressed (threaded end (A) touching the pad (B) on the pedal arm). Then, turn the switch 45° clockwise to lock it. The gap between the brake pedal position switch and the pad is automatically adjusted to 0.7 mm (0.028 in.) by locking the switch. Make sure the brake lights go off when the pedal is released.
5. Check the brake pedal free play.
Pedal Free Play
1. With the ignition switch off, inspect the pedal free play (A) on the brake pedal pad (B) by pushing the brake pedal by hand. If the brake pedal free play is insufficient, it may result in excessive brake drag. Check the brake pedal position switch (C) adjustment.
