Rear Suspension
Knuckle Bushing ReplacementSpecial Tools Required
Bushing driver 30-40 07NAD-SS00100 or 07NAD-SS00101
1. Position the knuckle (A) on the press with the machined surface (B) facing down.
2. Adjust the bushing driver so it matches the inner diameter of the bushing hole, then tighten the socket bolts (C) securely.
3. Position the bushing driver on the bushing (D).
4. Remove the bushing by pressing on the bushing driver with a press as shown.
NOTE: Be careful not to damage the inside of the bushing hole while pressing on the bushing.
5. Position the knuckle (A) on the press with the machined surface (B) facing up.
6. Adjust the bushing driver so it matches with the outer diameter of the bushing (C).
7. Position the bushing driver on the outer sleeve (D) of the bushing.
8. Press the bushing into the knuckle using the bushing driver as shown.