Advanced Diagnostics

DTC P0776: A/T Clutch Pressure Control Solenoid Valve B Stuck OFF







General Description
Hydraulic pressure to each clutch is controlled by the shift valve. The shift valve activates according to the ON/OFF status of shift solenoid valves A, B, C, D, and E. Hydraulic pressure supply in D position is shown above. The line pressure or the clutch pressure control pressure (CPC A, CPC B, or CPC C) is supplied to each clutch by the shift valve activated. The powertrain control module (PCM) computes the actual ratio of mainshaft and countershaft revolutions. If a difference between the actual ratio and the commanded gear occurs when shifting to each gear position, a malfunction in A/T clutch pressure control solenoid valve B or the hydraulic system is detected and a DTC is stored.




Monitor Execution, Sequence, Duration, DTC Type, OBD Status




Enable Conditions




Malfunction Threshold
Symptom 1-B occurs after Symptom 1-A occurs.

Driving Pattern
Start the engine, and accelerate the vehicle until the transmission shifts into 5th gear in D position.

- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.

Diagnosis Details

Conditions for illuminating the MIL
When a malfunction is detected during the first drive cycle, a Temporary DTC is stored in the PCM memory. If the malfunction recurs during the next (second) drive cycle, the MIL comes on and the DTC and the freeze frame data are stored.

Conditions for clearing the MIL
The MIL will be cleared if the malfunction does not recur during three consecutive trips in which the diagnostic runs.

The MIL, the DTC, the Temporary DTC, and the freeze frame data can be cleared by using the scan tool Clear command or by disconnecting the battery.