Operation CHARM: Car repair manuals for everyone.

System Decription

Immobilizer System

System Description










The vehicle is equipped with an immobilizer system that will disable the vehicle unless the proper ignition key is used. This system consists of a transponder located in the ignition key, an immobilizer control unit-receiver, an indicator, the IMOES unit ('07 model) and the ECM/PCM.

When the immobilizer key (programmed by the HDS) is inserted in the ignition switch and turned to the ON (II) position, the immobilizer control unit-receiver sends power to the transponder in the ignition key. The transponder then sends a coded signal back to the immobilizer control unit-receiver which then sends a coded signal to the ECM/PCM.

When the immobilizer key (programmed by the HDS) is inserted into the ignition switch and turned to the ON (II) position, the immobilizer control unit sends power to the transponder in the ignition key. The transponder then sends a coded signal back to the immobilizer control unit which sends a coded signal to the IMOES unit, which confirms the code and signals the ECM/PCM to supply power to the fuel pump circuit.
- If the proper key has been used, the immobilizer indicator will come on for about 2 seconds, then go off.
- If the wrong key has been used or the code was not received or recognized by the unit, the indicator will come on for about 2 seconds, then it will blink until the ignition switch is turned OFF.
- If the ignition switch is turned OFF, the indicator will blink for about 5 seconds to signal that the unit has reset correctly, then the indicator will go off.