Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2007 >> TSX L4-2.4L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag Control Module >> Service and Repair >> OPDS/ODS Unit Replacement

OPDS/ODS Unit Replacement

OPDS/ODS Unit Replacement

NOTE: Review the seat replacement procedure before doing repairs or service.

Removal

1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
2. Disconnect the front passenger's side airbag harness 2P connector.
3. Remove the front passenger's seat assembly and seat-back cover.




4. Remove the cover (A), then disconnect the OPDS unit 8P/ODS unit 18P connector 0 and sensor connectors (B) from the OPDS/ODS unit (C).
5. Remove the two screws (E) and the OPDS/ODS unit.

Installation




1. Place the new OPDS/ODS unit (A) on the seat-back frame. Tighten the two screws (B), and connect the OPDS unit harness 8P/ODS unit harness 18P connector D and sensor connectors (C) to the OPDS/ODS unit. Reinstall the cover (E).
2. Install the seat-back cover in the reverse order of removal.
3. Install the front passenger's seat assembly, then connect the side airbag harness 2P connector.
4. Reconnect the negative cable to the battery.
5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
6. Initialize the OPDS/ODS unit.
7. Calibrate the ODS unit ('06-07 models).
8. After installing the OPDS/ODS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM