Driver's Seat Position Sensor Replacement
Driver's Seat Position Sensor ReplacementRemoval ('06-07 models)
NOTE:
- Removal of the driver's seat position sensor must be performed according to the precautions/procedures described at the beginning of SRS.
- - Before disconnecting the driver's seat position sensor 2P Connector, disconnect the driver's airbag 4P connector.
- Do not turn the ignition switch ON (II), and do not connect the battery negative cable while removing the driver's seat position sensor.
1. Make sure you have the anti-theft codes for the audio and the navigation systems, then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the driver's seat assembly.
4. Disconnect the floor wire harness or seat position sensor harness 2P connector (A) from the driver's seat position sensor.
5. Remove the TORX bolt (B), then remove the driver's seat position sensor.
Installation ('06-07 models)
NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II), and do not connect the battery negative cable while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a TORX bolt (A), then connect the floor wire harness or seat position sensor harness 2P connector to the driver's seat position sensor (B).
2. Install the driver's seat assembly.
3. Reconnect the negative cable to the battery.
4. Check the operation of the driver's seat position sensor with the HDS.