Removal and Replacement
Starter Removal and InstallationRemoval
1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped).
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the intake manifold.
4. Disconnect the starter cable (A) from the B terminal, then disconnect the BLK/WHT wire (B) from the S terminal.
5. Remove the harness clamp (C).
6. Remove the harness holder (D).
7. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter. Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
2. Connect the starter cable (A) to the B terminal, then connect the BLK/WHT (B) to the S terminal.
3. Install the harness holder (C).
4. Install the harness clamp (D).
5. Install the intake manifold, '06-07 models.
6. Connect the positive cable to the battery first, then connect the negative cable.
7. Start the engine to make sure the starter works properly.
8. Enter the anti-theft codes for the audio system and navigation system (if equipped).
9. Set the clock.