Fluid Line/Hose: Service and Repair
ATF Cooler Hose Replacement1. Slide the ATF cooler hoses (A) on the ATF filter (B) until they are 5-6 mm (0.20-0.24 in.) away from the filter housing.
2. Secure the hoses with the clip (C) at 10-12 mm (0.39-0.47 in.) (D) from the filter housing.
3. Slide the ATF cooler hoses (F) over the ATF cooler lines (G).
4. Secure the hoses with the clips (H) at 5-6 mm (0.20-0.24 in.) (I) from the hose ends, and secure the hoses at the ATF cooler with the clips (J) at 2-4 mm (0.08-0.16 in.) (K) from the hose ends.
5. Install the hoses on the clamps (L) at the marks (M).