DTC 22-1x
DTC 22-1x ("x" can be 0 thru 9 or A thru F): Open in Front Passenger's Seat Belt TensionerDTC 22-2x ("x" can be 0 thru 9 or A thru F): Increased Resistance in Front Passenger's Seat Belt Tensioner
Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead F 07XAZ-SZ30100
NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information.
1. Clear the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on, and is DTC 22-1x or 22-2x indicated?
YES - Go to step 3.
NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. Troubleshooting Intermittent Failures If another DTC is indicated, troubleshoot the DTC.
3. Turn the ignition switch OFF. Disconnect the negative cable from the battery, then wait for 3 minutes.
4. Disconnect the right side wire harness 4P connector (A) from the front passenger's seat belt tensioner.
5. Connect the SRS inflator simulator (2 ohms connectors) and simulator lead F to the right side wire harness.
6. Reconnect the negative cable to the battery.
7. Clear the DTC memory.
8. Read the DTC.
Is DTC 22-1x or 22-2x indicated?
YES - Go to step 9.
NO - Open or increased resistance in the front passenger's seat belt tensioner; replace the front passenger's seat belt.
9. Turn the ignition switch OFF. Disconnect the negative cable from the battery, then wait for 3 minutes.
10. Disconnect the driver's seat belt tensioner connector.
11. Disconnect SRS unit connector B (28P) from the SRS unit.
12. Measure the resistance between the No. 3 and the No. 4 terminals of SRS unit connector B (28P). There should be 2.0 - 3.0 ohms.
Is the resistance as specified?
YES - Faulty SRS unit or poor connection at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.
NO - Open or increased resistance in the right side wire harness; replace the right side wire harness.