Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

Removal

1. Remove the mirror holder, the power mirror, and disconnect the power mirror 16P connector.
2. Record the 16P connector terminal location and wire harness color.
3. Disassemble the power mirror 16P connector (A), and remove the terminals from it.






4. Remove the gasket (A), then remove the screw and clip (B).






5. Remove the three TORX screws, and separate the mirror housing (A) from the bracket (B).






6. Remove the screws and separate the actuator (A) from the housing (B), then disconnect the side turn signal light 2P connector (C).






7. Remove the three screws and power mirror actuator (A).






Installation

8. Route the wire harness of the new actuator through the hole in the bracket and gasket.
9. Install the actuator, bracket, harness clip, and gasket in the reverse order of removal.
10. Install the new actuator terminals into the connector in the original arrangement as shown.






11. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator.
12. Reinstall the mirror assembly to the door.
13. Operate the power mirror to ensure smooth operation.