Headlamp Bulb: Service and Repair
Bulb ReplacementHeadlight Bulb (Low Beam)
WARNING: A transient high tension (25,000 V) occurs at the bulb sockets of the high intensity discharge (HID) lamps when the combination light switch is turned ON, it may cause serious electrical shock or electrocution if you do not observe the cautions.
CAUTION:
- Never turn on the combination light switch before fitting the HID bulbs to their bulb sockets and completing the reassembly of the headlight assembly.
- Do not service the headlights assembly in wet conditions, such as rain or snow, near a sprinkler system, or when your hands are wet to prevent electrocution.
- Do not touch the surface of the HID bulbs with your bare hands and do not stain it with any oils and fats.
- Do not disassemble the inverter unit and the igniter unit.
- Do not turn on the HID bulb by using a power source other than the battery mounted on your vehicle.
1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped). Make sure the ignition switch is OFF.
2. Turn the combination light switch OFF.
3. Disconnect the negative battery cable.
4. Remove the headlight assembly.
5. Turn the cover (A) 45° counterclockwise to remove it from the headlight assembly.
6. Turn the socket (A) 45° counterclockwise to remove it from the bulb (B).
7. Pull the retaining spring (C) away from the bulb then remove the bulb.
8. Make sure the bulb harness (D) is routed correctly so it does not contact the reflector.
9. Install the new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
10. Connect the negative cable to the battery.
11. Do the steering column position memorization.
12. Enter the anti-theft codes for audio system and navigation system (if equipped), and set the clock.
Headlight Bulb (High Beam)
1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped). Make sure the ignition switch is OFF.
2. Remove the left or right upper fender trim.
3. For the left headlight, remove the battery cover, remove the battery hold-down by removing the two nuts, then slide the battery to access the bulb.
4. Disconnect the 2P connector (A) from the headlight bulb socket (B).
5. Turn the bulb socket 45° counterclockwise to remove it from the headlight housing.
6. Install a new bulb in the reverse order of removal. Make sure the notches in the bulb align with the tabs in the headlight.
NOTE: Do not touch the glass of the bulb with your hands. If necessary, clean the glass area with alcohol.
7. If the battery is disconnected, do the steering column position memorization, and enter the anti-theft codes for the audio system and navigation system (if equipped), and set the clock.