Resetting the PAX System Warning
Resetting the PAX System WarningWhen a tire goes flat or is very low on pressure, the multi-information display will show "PAX SYSTEM WARNING, RUN FLAT DRIVING." After the tire is repaired or replaced, you must reset the warning indicator (and the mileage counter that supports it), no matter how far the vehicle was driven in the run flat mode.
1. Put the gauge control module into the self-diagnostic mode:
- Turn the headlight switch to ON.
- Press and hold the SELECT/RESET (SELECT/RESET Information switch).
- Turn the ignition switch to ON (II).
- Within 5 seconds, turn the headlights to AUTO, then to ON, and then to AUTO again.
- Within 5 seconds, release the SELECT/RESET switch, then push and release the switch three times.
2. Once the gauge control module is in the self-diagnostic mode, press and hold the INFO button on the steering wheel for 5 seconds to get to the CUSTOMIZE MENU.
3. With the INFO button, scroll through to the PAX RESET screen, then press the SEL/RESET button on the steering wheel.
4. With the INFO button, scroll through to the appropriate wheel, then press the SEL/RESET button on the steering wheel to reset the system warning. The screen should display PAX RESET "COMPLETED".
5. Use the INFO button to scroll through to EXIT, then press the SEL/RESET button.
6. Turn the ignition switch OFF to exit the self-diagnostic mode.