Operation CHARM: Car repair manuals for everyone.

How TPMS Works

System Indicator Location

TPMS System Indicator Location:





How TPMS Works ('08 model)

The TPMS (Tire Pressure Monitoring System) has many indicators: a low tire pressure indicator (LED indicator), a system indicator, and the tire(s) indicator (shown on the multi-information display). When the TPMS control unit detects low pressure in a tire or a problem in the system, it turns on, or blinks the appropriate indicator(s).

- If low tire pressure is detected, the low tire pressure indicator and the appropriate tire indicator come on.
- If a problem in the system is detected, the TPMS indicator comes on, and the low tire pressure indicator comes on after blinking for about 75 seconds.
- If low tire pressure and a problem in the system are detected the TPMS indicator comes on, and the low tire pressure indicator comes on after blinking for 75 seconds. In this case the low tire pressure indicator will be warming of the system failure.

If the system is OK, the low tire pressure indicator should come on when you turn the ignition switch ON (II), and then go off 2 seconds later. If it doesn't, there is a problem with the system.

If the system detects low pressure in any of the four tires, the low tire pressure indicator comes on and the appropriate tire indicator(s) will show on the multi-information display, and the control unit will set one or more of these codes: DTC 11, 13, 15, 17. When the tire pressure returns to normal, the control unit will turn off the indicators and store the DTC(s). However, if the control unit detects a problem in the system during an indication of low tire pressure, it will turn off the tire indicators, store the DTC(s), and turn on the TPMS indicator and the low tire pressure indicator after blinking.

NOTE: Tire pressures will increase slightly as the temperature in the tires rises during driving at highway speeds. Pressures will also increase or decrease slightly with changes in outside air temperature. A temperature change of about 50°F (10°C) will change tire pressure by about 10 kPa (0.1 kgf/cm2, 1.5 psi). If the temperature drops and then rises, tire pressure could decrease just enough to turn on the low pressure and tire(s) indicators, but later increase enough to turn them off. To resolve a complaint of such intermittent indications, confirm and clear the stored DTC(s) and check the tire pressures. Then explain to the client how temperature changes can affect the system, especially when tire pressures are near the low end of the TPMS normal range - 168 to 220 kPa (1.7 to 2.2 kgf/cm2, 24 to 32 psi).

If a problem is detected in the system, the TPMS indicator and the low tire pressure indicator (start blinking) will come on and stay on until the system returns to normal with most DTCs. If DTC 45, 51, 53, 55, 57, 81, 83, or 85 is set, the TPMS indicator will go off only when the ignition switch is turned off.

If a flat tire is replaced with the spare tire, and the flat tire is stored in the cargo area, the low tire pressure indicator will stay on but the appropriate tire indicator will go off. This prevents the client from thinking there is a problem with the spare tire. When the flat tire is taken out of the vehicle for repair, the TPMS indicator and the low tire pressure indicator (start blinking) will come on showing a (DTC 32, 34, 36, or 38) because the system is no longer receiving the signal from the tire's transmitter.