Stall Speed Test
Stall Speed Test1. Make sure the transmission fluid is filled to the upper level.
2. Apply the parking brake, and block all four wheels.
3. Connect the HDS to the DLC (A), and go to the A/T data list. If the HDS does not communicate with the PCM, troubleshoot the DLC circuit.
4. Make sure the A/C switch OFF.
5. After the engine has warmed up to normal operating temperature (the radiator fan comes on), shift to D.
6. Firmly press and hold the brake pedal, then fully press the accelerator pedal for 6 to 8 seconds, and note the engine speed. Do not move the shift lever while raising the engine speed.
7. Allow 2 minutes for cooling, then repeat the test in R.
NOTE:
^ Do not test stall speed for more than 10 seconds at a time.
^ Record the engine speed at 6-8 seconds after pressing the accelerator pedal. Higher engine speed will be indicated for 5 seconds.
^ Stall speed tests should be used for diagnostic purposes only.
^ The stall speed should be the same in D and R.
^ Do not test stall speed with the A/T pressure gauges installed.
Stall Speed rpm:
Specification: 1,850 rpm
Service Limit: 1,700-2,000 rpm
8. If any of the stall speeds are out of the service limit, refer to the problems and probable causes listed in the table.