Operation CHARM: Car repair manuals for everyone.
Home >> Acura >> 2008 >> RL V6-3.5L >> Repair and Diagnosis >> Restraints and Safety Systems >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> OPDS Unit Replacement

OPDS Unit Replacement

OPDS Unit Replacement

Removal

1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the passenger's side airbag harness 2P connector.
3. Remove the passenger's seat assembly and seat-back cover.
4. Remove the cover (A), then disconnect the OPDS unit 8P connector (D) and sensor connectors (C) from the OPDS unit (B).






5. Remove the two screws (E) and the OPDS unit.

Installation

1. Place the new OPDS unit (A) on the seat-back frame. Tighten the two screws (B), and connect the OPDS unit harness 8P connector D and sensor connectors (C) to the OPDS unit. Reinstall the cover (E).






2. Install the seat-back cover in the reverse order of removal.
3. Install the seat assembly, then connect the side airbag harness 2P connector.
4. Reconnect the negative cable to the battery.
5. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
6. Initialize the OPDS unit.
7. After installing the OPDS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM