Driver's Seat Position Sensor Replacement
Driver's Seat Position Sensor ReplacementRemoval
NOTE:
- Removal of the driver's seat position sensor must be done according to Precautions and Procedures.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
1. Move the driver's seat all the way back, all the way up, then tilt the seat-back all the way forward.
2. Disconnect the negative cable from the battery, then wait for 3 minutes.
3. Disconnect the driver's airbag 4P connector.
4. Remove the rear cover from the inner seat rail.
5. Disconnect the left side wire harness 2P connector (A) from the driver's seat position sensor.
6. Remove the mounting nut (B), then remove the driver's seat position sensor.
Installation
NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a mounting nut (A), then connect the left side wire harness 2P connector to the driver's seat position sensor (B). Reinstall the seat cover.
2. Reconnect the driver's airbag 4P connector.
3. Reconnect the negative cable to the battery.
4. Check the operation of the driver's seat position sensor with the HDS.