Steering Column Removal and Installation
Steering Column Removal and InstallationSRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
Removal
1. Make sure you have the anti-theft codes for the audio and the navigation system.
2. Adjust the steering column to full tilt down position, and to the full telescopic out position.
3. Disconnect the negative cable from the battery.
4. Remove the driver's airbag assembly and the steering wheel.
5. Remove the steering joint cover A.
6. Remove the upper column cover (A), and disconnect the connectors from the tilt/telescopic switch (B) on the lower column cover (C).
7. Disconnect the wire harness connectors from the combination switch assembly (D).
8. Remove the combination switch assembly from the steering column shaft by removing the screws (E).
9. Disconnect the connectors from the ignition switch, and release the wire harness clips from the steering column.
10. Disconnect the connectors from the tilt/telescopic motors (F).
11. Disconnect the connectors from the tilt/telescopic control unit (G).
12. Remove the steering joint bolts (H), then disconnect the steering joint (I) from the pinion shaft and the steering column shaft.
13. Remove the steering column (J) by removing the attaching nuts and bolts.
Installation
1. Install the steering column in the reverse order of removal, and note these items:
^ Make sure the wires are not caught or pinched by any parts.
^ Take care not to let the sliding capsules fall out of position during column installation.
2. Center the steering rack within its stroke.
3. Install the steering joint (A) aligning the slit (B) of the steering joint with the tab (C) of the center guide. Position the angle of the center guide as shown if necessary.
4. With the rack in the straight ahead driving position, slip the lower end of the steering joint on to the pinion shaft (D).
5. Align the bolt hole (A) on the steering joint with the groove (B) around the pinion shaft, and loosely install the joint bolts (C). Be sure that the joint bolt is securely in the groove in the pinion shaft. Pull on the steering joint to make sure that the steering joint is fully seated. Tighten the steering joint bolt to the specified torque.
6. Install the steering wheel.
7. Reconnect the negative battery cable to the battery, and do these tasks:
^ Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
^ Enter the anti-theft code for the audio system and the navigation system.
^ Make sure the horn and turn signal switches work properly.
^ Make sure the steering wheel switches work properly.
^ Make sure the steering wheel is centered.
^ Do the steering column position memorization.
^ Do the steering angle neutral position memorization.
8. After installation, do these checks:
^ Check the steering wheel spoke angle. If steering spoke angles to the right and left are not equal (steering wheel and rack are not centered), correct the engagement of the joint/pinion shaft serrations.
^ Set the steering column to the center tilt position, then do the front toe inspection.