B2240
DTC B2240: XM Antenna Error1. Connect the HDS to the DLC.
2. Turn the ignition switch to ON (II).
3. Clear the DTC with the HDS.
4. Turn the ignition switch to LOCK (0), then turn it ON (II) and wait 30 seconds or more.
5. Check for DTC with the HDS.
Is DTC B2240 indicated?
YES - Go to step 6.
NO - Intermittent failure, XM antenna is OK at this time. Check for poor connections or loose terminals at the AcuraLink control unit (XM receiver) and XM antenna.
6. Check the XM antenna lead connection at the AcuraLink control unit (XM receiver) and at the XM antenna.
Is it connected properly?
YES - Go to step 7.
NO - Reconnect the connector, and recheck the DTC.
7. Turn the ignition switch to LOCK (0).
8. Disconnect AcuraLink control unit (XM receiver) connector B (2P).
9. Turn the ignition switch to ON (II).
10. Measure the voltage between the body ground and the AcuraLink control unit (XM receiver) terminal B (2P) No. 1 terminal.
Is there about 4.5 V?
YES - Go to step 11.
NO - AcuraLink control unit (XM receiver) is faulty, replace the AcuraLink control unit (XM receiver).
11. Turn the ignition switch to LOCK (0).
12. Disconnect XM antenna 2P connector.
13. Check for continuity between body ground and XM antenna 2P connector No. 1 terminal.
Is there continuity?
YES - Replace the antenna lead between the AcuraLink control unit (XM receiver) and XM antenna.
NO - Go to step 14.
14. Check for continuity between XM antenna 2P connector terminal No.1 and No.2 (outside of the freeder).
Is there continuity?
YES - Replace the antenna lead between the AcuraLink control unit (XM receiver) and XM antenna.
NO - Go to step 15.
15. Reconnect AcuraLink control unit B (2P) connector.
16. Turn the ignition switch to ON (II).
17. Measure the voltage between the body ground and the XM antenna 2P connector No. 1 terminal.
Is there about 4.5 V?
YES - XM antenna is faulty, replace the XM antenna.
NO - Replace the antenna lead between the AcuraLink control unit (XM receiver) and the XM antenna.