DTC 26-22

DTC 26-22: Acceleration Sensor Stuck

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD.
3. Turn the ignition switch OFF, then turn it ON (II) again.
4. Check for DTCs with the HDS.

Is DTC 26-22 indicated?

YES - Go to step 5.

NO - if any DTCs are indicated, go to the indicated DTCs troubleshooting. If DTCs are not indicated, intermittent failure, the system is OK at this time.

5. Check the LATERAL ACCELERATION SENSOR and YAW RATE S in the VSA DATA LIST with the HDS.

Is there zero degrees indicated?

YES - Go to step 6.

NO - Replace the yaw rate-lateral acceleration sensor.

6. Test-drive the vehicle. Check the YAW RATE S in the VSA DATA LIST with the HDS while driving in corners.

Does the indicated value change?

YES - Intermittent failure, the system is OK at this time.

NO - Replace the yaw rate-lateral acceleration sensor.