DTC 64-11

DTC 64-11: Steering Angle Sensor Power Circuit Short

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF, then turn it ON (II) again.
4. Check for DTCs with the HDS.

Is DTC 64-11 indicated?

YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time.

5. Turn the ignition switch OFF.
6. Disconnect the steering angle sensor 5P connector.
7. Disconnect the yaw rate-lateral acceleration sensor 5P connector.
8. Disconnect the VSA modulator-control unit 37P connector.
9. Check for continuity between steering angle sensor 5P connector terminal No. 5 and body ground.





Is there continuity?

YES - Repair Short to body ground in the wire between the steering angle sensor and the VSA modulator-control unit.

NO - Replace the VSA modulator-control unit.