DTC 68-22

DTC 68-22: Brake Pedal Position Switch Stuck ON

1. Turn the ignition switch ON (II).
2. Check the BRK PRESS in the VSA DATA LIST with the HDS. Do not press the brake pedal.

Is there 10 MPa or more?

YES - Check the brake pedal height if the brake pedal height is OK, replace the VSA modulator-control unit.

NO - Go to step 3.

3. Check the BRAKE SWITCH in the VSA DATA LIST with the HDS while moving the brake pedal.

Does it indicate ON when the pedal is pressed, and OFF when the pedal is released?

YES - Intermittent failure, the system is OK at this time.

NO - Go to step 4.

4. Check the BRAKE SWITCH in the VSA DATA LIST with the HDS, and disconnect the brake pedal position switch 4P connector.

Does the indicator change from ON to OFF?

YES - Replace the brake pedal position switch.

NO - Go to step 5.

5. Turn the ignition switch OFF.
6. Short the SCS line with the HDS.
7. Disconnect ECM/PCM connector E (31P).
8. Turn the ignition switch ON (II).
9. Measure voltage between brake pedal position switch 4P connector terminal No. 2 and body ground.





Is there 0.1 V or more?

YES - Repair Short to power in the wire between the ECM/PCM and the brake pedal position switch.

NO - Substitute a known-good ECM/PCM, then Go to step 1 and recheck. If DTCs are not indicated, replace the original ECM/PCM.