Front Bumper Cover / Fascia: Service and Repair

Front Bumper Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

NOTE:
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Put on gloves to protect your hands.
- Have an assistant help you when removing and installing the front bumper.
- Take care not to scratch the front bumper and body.

1. Remove these items:
- Front bulkhead cover
- Front strake




2. Remove the bolts (A), screws (B), and clips (C) securing the front bumper (D).




3. Pull on the front bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacers (C).




4. With the help of an assistant, pull the wheel arch portion away from the side spacer (A) while pulling the front bumper to release the bumper from the hooks (B) on the corner upper beam (C).




5. Disconnect the fog light connector (A), then remove the front bumper (B).




6. Release the hooks, then remove the front bumper absorber (A) from the front bumper beam (B).
7. Install the bumper in the reverse order of removal, and note these items:
- Make sure the front bumper engages the hooks (of both corner upper beams and side spacers) on each side securely.
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Make sure the fog light connectors are plugged in properly.
- Push the clips and hooks into place securely.