Keyless Entry Transmitter: Testing and Inspection

Keyless Transmitter Programming/Deleting-Manual Method

NOTE: The keyless transmitter attaches to the ignition key and is separate from the immobilizer transponder. It is not necessary to use the HDS when replacing or deleting an existing transmitter.

- Adding a key (transponder) can only be done with the HDS. If the key being added has a new remote transmitter, it can be programmed with the HDS at the end of the "ADD A KEY" function.
- If one or all keys (transponders) are lost, the remote transmitters must be deleted manually. This will assure that all of the old keyless transmitters have been cleared from the keyless receiver units memory.
- When replacing the keyless receiver unit, you must have all of the remote transmitters that need to be programmed to the car.
- The keyless receiver unit can only store 5 keyless transmitters.
- During programming, pushing the same remote button 5 times will delete all other remotes.

Adding a remote transmitter

Turn the ignition switch ON (II), push the transmitter's lock or unlock button within 4 seconds and turn the ignition switch OFF, turn it back ON (II) within 4 seconds and back OFF. Repeat this 2 more times and the locks should cycle when the transmitter button is pushed. Turn the ignition switch OFF and remove the key. Wait 10 seconds and verify that all remotes function properly.

Adding multiple remote transmitters

Turn the ignition switch ON (II), push the transmitter's lock or unlock button within 4 seconds and turn the ignition switch OFF, turn it back ON (II) within 4 seconds and back OFF. Repeat this 2 more times and the locks should cycle when the transmitter button is pushed. Push the lock or unlock button on each remote to be programmed within 4 seconds of each other. Turn the ignition switch OFF and remove the key. Wait 10 seconds and verify that all remotes being programmed are functioning properly.

Deleting remotes

Turn the ignition switch ON (II), push the transmitter's lock or unlock button within 4 seconds and turn the ignition switch OFF, turn it back ON (II) within 4 seconds and back OFF. Repeat this 2 more times and the locks should cycle when the transmitter button is pushed. Push the same button 5 more times. This will leave only the current remote programmed in the keyless receiver unit.