Rearview Mirror Replacement

Rearview Mirror Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the roof console.




2. Disconnect the connector (A), and carefully remove the bracket cover (B) by releasing the hooks (C). Take care not to scratch the cover and mirror bracket (D).




3. Slide the rearview mirror (A) forward to release the spring (B) by gently tapping the mirror bracket with a flat4ip screwdriver wrapped with a clean shop towel and a plastic hammer. Remove the mirror from the lug (C).




4. Remove the wire cover (A) from the mirror bracket (B) by releasing the hooks (C) in the sequence shown.




5. Install the rearview mirror (A) by sliding it over the lug (B) until the spring contacts the lug. Gently tap the mirror bracket with a flat-tip screwdriver wrapped with a clean shop towel and a plastic hammer. Be careful not to damage the wires.




6. Install the wire cover (A) in the sequence shown. Take care not to damage the hooks (B).
7. Install the bracket cover, and connect the connector, then install the roof console.