Glass Position Adjustment

Glass Position Adjustment




The roof panel (A) should be even with the glass weatherstrip (B), to within 0 + 1/ - 1 mm (0 + 0.04/ - 0.04 in.) all the way around. If not, make the following adjustment:

NOTE: Do the moonroof motor calibration procedure. If glass position is still incorrect, go to step 1.




1. Make sure that the tips of the molding (A) are pointing up. Using a T25 TORX bit, loosen the bolts on one side, and adjust the glass (B).

2. If necessary, repeat on the opposite side.

NOTE: After glass position is mechanically adjusted. Do the moonroof calibration.