Paddle Shifter + (Upshift Switch) Test

Paddle Shifter + (Upshift Switch) Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS before doing repair or service.

1. Remove the steering wheel.
2. Check the paddle shifter + (upshift switch) for continuity between steering wheel switch harness 20P connector terminals No. 15 and No. 7.There should be continuity while pressing the paddle shifter + (upshift switch), and no continuity when the paddle shifter + is released.





3. The paddle shifter + (upshift switch) test is finished if the test result is OK.
If the paddle shifter + works incorrectly at the 20P connector, test the paddle shifter + at the connector.
4. Remove the paddle shifter + (upshift switch) connector from its holder, and disconnect the connector.





5. Check the paddle shifter + (upshift switch) for continuity between the paddle shifter + (upshift switch) connector terminals while pressing the paddle shifter + and when the paddle shifter + is released.
There should be continuity while pressing the paddle shifter +, and no continuity when the paddle shifter + is released.
6. Replace the paddle shifter + (upshift switch) if the paddle shifter + works incorrectly.
7. Replace the steering wheel switch harness if the paddle shifter + is OK.