Dynamic Damper Replacement

Dynamic Damper Replacement
1. Remove the inboard joint.
2. Remove the dynamic damper band.
^ If the band is a welded type, cut the band.
^ If the band is a double loop type, lift up the band end, then push it into the clip.
^ If the band is a low profile type, pinch the band using commercially available boot band pliers.

3. Remove the dynamic damper.





4. Install the new dynamic damper, and adjust to these measurements.

NOTE: Be careful not to swap the dynamic dampers. The right and the left dynamic dampers are different.





5. Install the dynamic damper band.
6. Install the inboard joint.