Start-Up Procedure and Diagnostic Menu
Start-up procedure and Diagnostic MenuThere are two ways to enter the diagnostic mode:
1. Connect the SCS service connector to the navigation service connector located in the trunk. Turn the ignition switch to ON (II). The display will go directly to the diagnostic menu screen.
NOTE: When finished troubleshooting, make sure to remove the SCS service connector.
2. Turn the ignition switch to ON (II).
Use the navigation display hard buttons, press and hold the 3 buttons (Menu, Map/Guide, and Cancel), and keep them pressed for about 5 seconds. The display screen will go directly to the "Select Diagnosis Items" menu.
3. After the display changes to the Select Diagnosis Items menu, select the item you want to check and the diagnostic will start. To return to the previous screen, select "RETURN".
- Navi System (Link)
- Monitor Check
- Unit Check
- Car Status
- F-CAN (System link)
- GPS Information
- Yaw Rate
- Tire Calibrate
- Functional Setup
- Version
- XM ((HIP)