2nd Clutch Transmission Fluid Pressure Switch Replacement
Automatic Transmission2nd Clutch Transmission Fluid Pressure Switch Replacement
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Remove the battery trim and the left upper fender cover.
3. Disconnect the negative cable from the battery, then disconnect the positive cable.
4. Remove the battery hold-down bracket, and remove the battery and the battery tray.
5. Remove the intake air duct and the air cleaner assembly.
6. Remove the two mounting bolts for the under-hood fuse/relay box, and swing it out of the way.
7. Disconnect the 2nd clutch transmission fluid pressure switch connector, and remove the 2nd clutch transmission fluid pressure switch (A) and the sealing washer (B).
8. Install a new 2nd clutch transmission fluid pressure switch and a new sealing washer, and tighten the switch.
9. Make sure there is no water, oil, dust, or foreign particles inside the connector.
10. Connect the connector securely.
11. Install the under-hood fuse/relay box.
12. Install the intake air duct and the air cleaner assembly.
13. Install the battery tray, the battery, and the battery hold-down bracket, then connect the battery terminals.
14. Install the left upper fender cover and the battery trim.
15. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).