Bearing Outer Race Replacement
Bearing Outer Race ReplacementSpecial Tools Required
^ Attachment, 78 x 80 mm 07NAD-PX40100
^ Driver 07749-0010000
NOTE:
^ The bearing outer race and tapered roller bearing should be replaced as a set.
^ Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
^ After you do this procedure, adjust the differential carrier bearing preload while reassembling the transmission.
1. Remove the oil seals from the transmission housing and clutch housing.
2. Remove the bearing outer race, spacer, and 81 mm thrust shim from the transmission housing, and the bearing outer race and spacer from the clutch housing by heating the housing to about 212°F (100°C) with a heat gun.
NOTE: Do not reuse the thrust shim if the outer race was driven out.
3. Install the 81 mm thrust shim (A), spacer (B), and bearing outer race (C) into the transmission housing (D) using the driver (E) and 78 x 80 mm attachment (F).
4. Install the spacer (A) and bearing outer race (B) into the clutch housing (C) using the driver (D) and 78 x 80 mm attachment (E).
5. Install the oil seals into the transmission housing and clutch housing.