Mainshaft Reassembly
Mainshaft ReassemblyMainshaft:
Special Tools Required
^ Driver, 40 mm I.D. 07746-0030100
^ Driver, 30 mm I.D. 07946-MB00000
NOTE: Refer to the Exploded View, as needed, during this procedure.
1. Clean all parts in solvent, dry them, and apply manual transmission fluid (MTF) to all contact surfaces except the 3rd/4th and 5th/6th synchro hubs.
2. Install the new angular ball bearing (A) using the 30 mm I.D. driver (B) and a press. Note the direction of installation.
3. Install the needle bearing (A) and 3rd gear (B) on the mainshaft (C).
4. Install the double cone synchro assembly (A) by aligning the synchro cone fingers (B) with the holes in 3rd gear (C), then install the synchro spring (D).
5. Install the 3rd/4th synchro hub (A) by aligning the outer synchro ring fingers (B) with the grooves in the 3rd/4th synchro hub (C).
6. Install the 3rd/4th synchro hub (A) using the 40 mm I.D. driver (B).
7. Install the 3rd/4th synchro sleeve (A) by aligning the stops (B) with the 3rd/4th synchro sleeve and 3rd/4th synchro hub. After installing, check the operation of the 3rd/4th synchro hub set.
8. Install the synchro spring (A).
9. Install the double cone synchro assembly (B) by aligning the outer synchro ring fingers (C) with the grooves in 3rd/4th synchro hub (D).
10. Install 4th gear (A) by aligning the synchro cone fingers (B) with the holes in 4th gear (C).
11. Install the needle bearings, distance collar, 5th gear, synchro ring, and synchro spring.
12. Install the 5th/6th synchro hub (A) by aligning the outer synchro ring fingers (B) with the grooves in 5th/6th synchro hub (C).
13. Install the 5th/6th synchro hub (A) using the 40 mm I.D. driver (B).
14. Install the 5th/6th synchro sleeve.
15. Install the synchro spring and synchro ring.
16. Install the distance collar, needle bearing, and 6th gear.
17. Install the new angular ball bearing (A) using the 40 mm I.D. driver (B). Note the direction of installation.
