SRS Component Replacement/Inspection After Deployment

Component Replacement/Inspection After Deployment

NOTE:
- Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index Diagnostic Trouble Code Descriptions for the less obvious deployed parts (seat belt tensioners, front impact sensors, side impact sensors, etc.).
- Do not replace the OPDS/ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting.

After a collision where the seat belt tensioners deployed, replace these items:
- SRS unit
- Seat belt tensioners
- Front impact sensors

After a collision where the front airbag(s) deployed, replace these items:
- SRS unit
- Deployed airbag(s)
- Seat belt tensioners
- Front impact sensors

After a collision where the side airbag(s) deployed, replace these items:
- SRS unit
- Deployed side airbag(s)
- Reinforcing cloth rear hooks
- Side impact sensor(s) (first) for the side(s) that deployed

After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
- SRS unit
- Deployed side curtain airbag(s)
- Side impact sensor(s) (first)
- Side impact sensor(s) (second)
- Roof trim
- A-pillar trim
- B-pillar trim
- C-pillar trim
- Front grab handle
- Sunvisor
- Any related trim clips

After a moderate to severe side or rear collision, inspect for damage on the side curtain airbag or other related components. Replace the components as needed.









During the repair process, inspect these areas:
- Inspect all the SRS wire harnesses. Replace, do not repair, any damaged harnesses.
- Inspect the cable reel for heat damage. If there is any damage, replace the cable reel.

After the vehicle is completely repaired, turn the ignition switch ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, use the HDS SRS Menu Method to read the DTC.

Checking and Adjusting the Headliner/Pillar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less then 15 mm (0.6 in.). To check the overlap, do this:

1. Install the headliner (A) and the pillar trim (B).






2. Using masking tape on the headliner, mark the upper edge of each pillar trim.






3. Remove the pillar trim, and measure the headliner overlap.
- If the overlap is less than 15 mm (0.6 in.), remove the tape, and install the pillar trim.
- If the overlap is more than 15 mm (0.6 in.), go to step 4.






4. Carefully trim the headliner with a utility knife, reducing the overlap to less than 15 mm (0.6 in.).






5. Remove the tape, and install the pillar trim.