Side Impact Sensor (Second) Replacement
Side Impact Sensor (Second) ReplacementRemoval
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the appropriate side curtain airbag 2P connector.
3. Disconnect the side impact sensor (second) 2P connector (A) from the side curtain airbag harness.
4. Using a TORX T30 bit, remove the TORX bolts (B), then remove the side impact sensor (second) (C).
Installation
1. Install the new side impact sensor (second) (A) with the TORX bolts (B), then connect the side curtain airbag harness 2P connector (C) to the side impact sensor (second).
2. Reconnect the negative cable to the battery.
3. Install all removed parts.
4. After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.