Removal and Replacement
Starter Removal and InstallationRemoval
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery.
3. Remove the intake manifold.
4. Disconnect the starter cable (A) from the B terminal, and disconnect the BLK/WHT wire (B) from the starter solenoid S terminal.
5. Remove the harness clamp (C) and the harness holder (D).
6. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter, then connect the starter cable (A) to the B terminal, and connect the BLK/WHT wire (B) to the starter solenoid S terminal. Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
2. Install the harness holder (C) and the harness clamp (D).
3. Install the intake manifold.
4. Connect the negative cable to the battery.
5. Start the engine to make sure the starter works properly.
6. Enter the anti-theft codes for the audio system and the navigation system (if equipped), then enter the audio presets. Set the clock (on vehicles without navigation).