B1229

DTC Troubleshooting: B1229 (TS sensor open)

DTC B1229 or TS sensor open is indicated:

An Open in the Sunlight Sensor Circuit

1. Clear the DTC with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Do the self-diagnostic with the HDS or the climate control unit.

4. Check for DTCs.

Is DTC B1229 or TS sensor open indicated?

YES -

Go to step 5.

NO -

Intermittent failure. Check for loose wires or poor connections on the sunlight sensor circuit.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect the sunlight sensor 5P connector.

7. Disconnect the climate control unit 40P connector.

8. Check for continuity between climate control unit 40P connector terminal No. 18 and sunlight sensor 5P connector terminal No. 4.





Is there continuity?

YES -

Go to step 9.

NO -

Repair an open in the wire between the climate control unit and the sunlight sensor.�

9. Check for continuity between climate control unit 40P connector terminal No. 33 and sunlight sensor 5P connector terminal No. 2.





Is there continuity?

YES -

Go to step 10.

NO -

Repair an open in the wire between the climate control unit and the sunlight sensor.�

10. Reconnect the sunlight sensor 5P connector.

11. Reconnect the climate control unit 40P connector.

12. Test the sunlight sensor Sunlight Sensor Test.

Is the sunlight sensor OK?

YES -

Check for loose wires or poor connections at the climate control unit 40P connector and at the sunlight sensor 5P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit Climate Control Unit Removal/Installation.�

NO -

Replace the sunlight sensor Service and Repair.�