B1657

DTC Troubleshooting: B1657

DTC B1657:

Trunk/Tailgate/Rear Bumper Antenna Circuit Shorted

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back to ON (II).

3. Select MODE MENU from the HDS, then enter SELF CHECK.

4. Check for DTCs with the HDS.

Is DTC B1657 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections.�

5. Turn the ignition switch to LOCK (0).

6. Disconnect keyless access control unit connector B (24P).

7. Disconnect the rear bumper LF antenna 2P connector.

8. Check for continuity between body ground and keyless access control unit connector B (24P) terminals No. 15 and No. 16 individually.





Is there continuity?

YES -

Repair a short to ground in the wire.�

NO -

Go to step 9.

9. Reconnect keyless access control unit connector B (24P).

10. Connect the voltmeter between rear bumper LF antenna 2P connector terminals No. 1 and No. 2.





11. Turn the ignition switch to ON (II).

12. Select FUNCTION TEST from the HDS, and do TRUNK/TAILGATE/REAR BUMPER ANTENNA L DC OUTPUT.

Is there voltage?

YES -

Replace the rear bumper LF antenna Keyless Access LF Antenna (Rear Bumper) Replacement.�

NO -

Replace the keyless access control unit Keyless Access Control Unit Input Test/Replacement.�