Manufacturer Code Charts: 2607
Navigation System DTC Troubleshooting: 2607
DTC 2607:
XM Diag
NOTE:
- Check the vehicle battery condition first Testing and Inspection.
- This navigation DTC sets when a problem (open or short) is detected in the GA-Net BUS.
- Check any official Honda service website for more service information about the navigation system.
- Before you troubleshoot, make sure to follow the general troubleshooting information How to Troubleshoot the Navigation System.
1. Clear the hard error code.
2. Turn the ignition switch to LOCK (0), and then back ON (II).
3. Check the hard error code.
Is DTC 2601 indicated at the time you cycled the vehicle?
YES -
Do the DTC 2601 troubleshooting 2601.
NO -
Go to step 4.
4. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode.
5. Check the System Links.
Is the XM (HIP) or XM icon red?
YES -
Go to step 6.
NO -
Intermittent failure, the system is OK at this time.�
6. Turn the ignition switch to LOCK (0).
7. Check for poor connections or loose terminals at AcuraLink control unit (XM receiver) connector, or XM receiver unit connector, satellite signal antenna connector, and the navigation display unit 20P connector.
Are there connections OK?
YES -
Go to step 8.
NO -
Repair poor connections or loose terminals.�
8. Disconnect these items:
- AcuraLink control unit (XM receiver) connector A (32P)
- XM receiver unit connector A (14P)
- navigation display unit 20P connector
9. Connect AcuraLink control unit (XM receiver) connector A (32P), or XM receiver unit connector A (14P) terminals No. 30 [or No. 9] and No. 31 [or No. 10] with a jumper wire.
[ ]: Without AcuraLink
10. Check for continuity between navigation display unit 20P connector terminals No. 5 and No.15.
Is there continuity?
YES -
Do the AcuraLink control unit (XM receiver), or the XM receiver troubleshooting.�
NO -
There is an open in the wire between the navigation display unit and the AcuraLink control unit (XM receiver), or the XM receiver. Replace the affected shielded harness.�