53-FF

SRS DTC Troubleshooting: 53-FF

DTC 53-FF:

SRS Unit Programming Error

NOTE:

- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
- This DTC is indicated when a SRS unit update is not completed properly.
- Do not turn the ignition switch to ACC (I) or LOCK (0) while updating the SRS unit. If you turn the ignition switch to ACC (I) or LOCK (0) before you complete the SRS unit update procedure, the SRS unit can be damaged.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.

1. Do the SRS unit update procedure SRS Unit Update.

2. Clear the DTCs with the HDS.

3. Turn the ignition switch to LOCK (0).

4. Turn the ignition switch to ON (II), then wait for 10 seconds.

5. Check for DTCs with the HDS.

Is DTC 53-FF indicated?

YES -

Replace the SRS unit SRS Unit Replacement.�

NO -

Update is complete.�