A/T System

DTC Troubleshooting: U0104 (107-6)

DTC U0104:

Lost Communication with Adaptive Cruise Control (ACC) Unit-PCM

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information How to Troubleshoot the A/T System.
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Check for Pending or Confirmed DTCs in the PGM-FI SYSTEM with the HDS.

Is DTC U0104 indicated in the PGM-FI SYSTEM?

YES -

Go to the DTC U0104 troubleshooting in the PGM-FI SYSTEM U0104.�

NO -

Go to step 4.

4. Check for Pending or Confirmed DTCs in the A/T SYSTEM with the HDS.

Is DTC U0104 indicated in the A/T SYSTEM?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. If any other Pending or Confirmed DTCs or DTCs were indicated, go to the indicated DTC's troubleshooting.�

5. Update the PCM if it does not have the latest software PCM Update, or substitute a known-good PCM.

6. Turn the ignition switch to ON (II), and wait for at least 2 minutes.

7. Check for Pending or Confirmed DTCs in the A/T SYSTEM with the HDS.

Is DTC U0104 indicated in the A/T SYSTEM?

YES -

Check for poor connections or loose terminals at the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 2. If the PCM was substituted, go to step 6.

NO -

Go to step 8.

8. Monitor the OBD STATUS for U0104 in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES -

If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM Service and Repair. If any other Pending or Confirmed DTCs or DTCs were indicated in step 7, go to the indicated DTC's troubleshooting.�

NO -

If the HDS indicates FAILED, check for poor connections or loose terminals at the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 6. If the PCM was substituted, go to step 2. If the HDS indicates NOT COMPLETED, go to step 6.