Keyless Entry Transmitter (Remote) Test

Keyless Entry Transmitter (Remote) Test

NOTE:

- If the doors unlock or lock with the remote, but the LED on the remote does not come on, the LED is faulty; replace the remote.
- If any door is open, you cannot lock the doors with the remote.
- If the UNLOCK button is pressed on the remote and a door is not opened within 30 seconds, the doors relock automatically.
- The doors do not lock or unlock with the remote if the key is in the ignition switch.
- Panic function will not operate if the ignition switch is ON (II).
- If the lock and unlock function works normally, but the driving position memory system (DPMS) is not linked, confirm the link is turned ON with the HDS, then check for problems in the DPMS Initial Inspection and Diagnostic Overview or B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A. Refer to System Description Keyless/Power Door Locks/Security System Description for more information.

With HDS

Do a remote test using the HDS by selecting the KEYLESS INSPECTION menu.

Without HDS

1. Open the remote and check for water damage.

- If you find any water damage, replace the remote.
- If there is no water damage, go to step 2.

2. Replace the remote batteries (A) with new ones (CR2025), and try to lock and unlock the doors with the remote by pressing the lock or unlock button 5 or 6 times.

- If the doors lock and unlock, the remote is OK.
- If the doors do not lock and unlock, go to step 3.





3. Reprogram the remote with the HDS, then try to lock and unlock the doors.

- If the doors lock and unlock, the remote is OK.
- If the doors do not lock and unlock, try and program to another vehicle.
- If the remote programs to another vehicle, go to B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.
- If the remote will not program to another vehicle, replace it.