IMOES Unit Input Test

Imoes Unit Input Test

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the audio unit Audio Unit Removal / Installation.

2. Remove the passenger's front console cover.

NOTE: If necessary, remove the glove box Glove Box Removal / Installation to make a space to see the imoes unit from the front passenger's side.

3. Disconnect the 5P connector (A) from the imoes unit (B).





4. Inspect the connector and socket terminals to be sure they are all making good contact.

- If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
- If the terminals look OK, go to step 5.

5. With the connector still disconnected, do the following input tests.

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, go to step 6.





6. Reconnect the connector to the unit, turn the ignition switch to ON (II), and do the following input tests.

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, replace the imoes unit IMOES Unit Replacement.