Mirror Holder Replacement

Mirror Holder Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the mirror housing.

1. Carefully push on the top edge of the mirror holder (A) by hands.






2. Put a shop towel (B) in the opening between the bottom edge of the mirror holder and the mirror housing (C) to prevent scratch, and release the bottom hooks (D) with the appropriate trim tool.

3. Carefully pull out the bottom edge of the mirror holder (A), then release the side hooks (B). Separate the mirror holder from the actuator (C) by releasing the hooks (D). Disconnect the mirror defogger connectors (E) from the heater pad terminals.






4. Before installing the mirror holder to the inner holder (A) of the actuator, check the actuator rods (B) and the actuator boots (C):

NOTE: Make sure each actuator rod is inserted into the actuator securely, and each actuator boot is fully seated on the actuator.





5. Reconnect the mirror defogger connector.

6. Reattach the hooks of the mirror holder to the actuator, then position the mirror holder on the actuator. Carefully push on the hooks of the mirror holder until the mirror holder locks into place.

7. Check the operation of the actuator.