Front Seat Slide Motor Replacement

Front Seat Slide Motor Replacement

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Take care not to kink the cable.

1. Remove the front seat Front Seat Removal / Installation.

2. Remove the flex cable (A) and the cable housing (B).

1. Release the housing from the hooks (C).

2. Disconnect the cable from the worm gear (D) in the inner seat track by pulling out the housing.

3. Disconnect the cable from the slide motor (E).





3. Disconnect the slide motor connector (A), and remove the screws, then remove the slide motor (B) from the slide motor bracket (C) while disconnecting the motor from the short flex cable (D).






4. Pull out the short flex cable (A) from the worm gear (B) in the outer seat track.





5. Install the motor in the reverse order of removal, and note these items:

- Apply multipurpose grease to the worm gear portions in both seat tracks.
- Before installing the slide motor to the slide motor bracket, install the short flex cable to the slide motor.
- Before installing the slide motor bracket to the seat tracks, make sure both seat tracks are located forward fully.
- Make sure the short flex cable and the flex cable are connected properly.