Programming and Relearning

ACC Unit Update

Special Tools Required

- Honda Diagnostic System (HDS) tablet tester
- Honda Interface Module (HIM) and an iN workstation with the latest HDS software version
- HDS Pocket Tester
- GNA600 and an iN workstation with the latest HDS software version
Available through the Acura Tool and Equipment Program 888-424-6857

Any one of the above updating tools can be used.

NOTE:

- Use this procedure anytime you need to update the ACC unit.
- Make sure the HDS/iN workstation has the latest HDS software version.
- Before you update the ACC unit, make sure the battery in the vehicle is fully charged.
- Never turn the ignition switch to LOCK(0) or ACC (I), during the update. If there is a problem with the update, turn the ignition switch to ON (II).
- To prevent ACC unit damage, do not operate anything electrical (headlights, audio system, brakes, A/C, power windows, moonroof, door locks, etc.) during the update.
- To ensure the latest program is installed, do an ACC unit update whenever the ACC unit is replaced.
- You cannot update an ACC unit with a program it already has. It will only accept a new program.
- If you need to diagnose the HIM because the HIM's red (#3) light came on or was flashing during the update, leave the ignition switch in ON (II) when you disconnect the HIM from the data link connector (DLC). This will prevent ACC unit damage.
- DTCs stored in memory are cleared when the ACC unit is updated.

1. With the ignition switch in LOCK (0), and connect the HDS (Honda Diagnostic System) to the data link connector (DLC) (A) located under the driver's side of the dashboard.






2. Turn the ignition switch to ON (II), but do not start the engine.

3. Make sure the HDS communicates with the vehicle and the ACC unit. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.

4. Select the update program, and follow the screen prompts to update the ACC unit.

5. If the software in the ACC unit is the latest, disconnect the HDS/HIM from the DLC, and go back to the procedure that you were doing. If the software in the ACC unit is not the latest, follow the instructions on the screen.

NOTE: If you run into a problem during the update procedure (programming takes over 15 minutes, status bar goes over 100 %, D or immobilizer light flashes, HDS tablet freezes, etc.), follow these steps to minimize the chance of damaging the ACC unit:

- Turn the ignition switch to ON (II).
- Connect a jumper battery (do not connect a battery charger).
- Shut down the HDS.
- Disconnect the HDS from the DLC.
- Reboot the HDS.
- Reconnect the HDS to the DLC, and try the update procedure again.

6. Turn the ignition switch to LOCK (0).

7. Disconnect the HDS from the DLC.