Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation

Radiator and A/C Condenser Fan, Motor, and Shroud Removal and Installation

Removal

1. Remove the right side fender trim .

2. Raise the vehicle on the lift.

3. Remove the splash shield Service and Repair.

4. Remove the harness connectors (A), the ground cable (B), and the harness clamps (C).





5. Loosen the A/C condenser fan shroud mounting bolts (D).

6. Lower the vehicle on the lift.

7. Remove the air intake duct cover (A) and the coolant reservoir (B).






8. Disconnect the RFC connectors (A) and the A/C condenser fan motor connector (B), then remove the harness clamps (C).





9. Remove the RFC unit from the radiator fan shroud RFC Unit Replacement.

10. Remove the A/C condenser fan shroud assembly (A), then remove the radiator fan shroud assembly (B).

NOTE: Pull-up the radiator, then move the radiator fan shroud assembly toward the right side of the vehicle to allow for enough space to lift it up and away from the A/C condenser fan shroud assembly.






11. Disassemble the fan shrouds.






Installation

1. Assemble the fan shrouds.






2. Install the radiator fan shroud assembly (A).





3. Install the A/C condenser fan shroud assembly (B).

4. Install the RFC unit RFC Unit Replacement.

5. Connect the RFC connectors (A) and the A/C condenser fan motor connector (B), then install the harness clamps (C).






6. Install the coolant reservoir (A), and the air intake duct cover (B).





7. Raise the vehicle on the lift.

8. Tighten the A/C condenser fan shroud mounting bolts (A).





9. Install the harness connectors (B), the ground cable (C), and the harness clamps (D).

10. Install the splash shield Service and Repair.

11. Lower the vehicle on the lift.

12. Install the right side fender trim .