Front Passengers Airbag Cutoff Indicator Illumination Bulb Test

Front Passenger's Airbag Cutoff Indicator Illumination Bulb Test

1. Remove the passenger's vent panel Passenger's Vent Panel Removal/Installation.

2. Push out the front passenger's airbag cutoff indicator from behind the passenger's vent panel.

3. Disconnect the dashboard wire harness 6P connector (A) from the front passenger's airbag cutoff indicator (B).





4. Check for continuity between the No. 3 and No. 4 terminals of the indicator. If there is no continuity, replace the both bulbs (C).

NOTE: Both illumination bulbs are connected in parallel. If there is continuity, remove the upper, hazard switch illumination bulb, and recheck for continuity. If there is no continuity, replace the lower, front passenger's airbag cutoff indicator illumination bulb.

5. Reinstall the parts in the reverse order of removal.