Operation CHARM: Car repair manuals for everyone.

Front Impact Sensor Replacement




Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front bumper Front Bumper Removal / Installation.

3. Disconnect the engine compartment wire harness 2P connector (A) from the front impact sensor.





4. Remove the TORX bolts (B) using a TORX T30 bit, then remove the front impact sensor (C).

Installation

1. Install the front impact sensor with new TORX bolt (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).





2. Do the battery terminal reconnection procedure.

3. Clear any DTCs with the HDS.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator should come on for about 6 seconds and then go off.

5. Reinstall all removed parts.