Torque Converter Housing Main Shaft Bearing and Oil Seal Replacement

Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Bearing Remover Shaft 07JAC-PH80200
- Slide Hammer 07936-371020A
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 62 x 68 mm 07746-0010500
- Bearing Driver Attachment, 72 x 75 mm 07746-0010600

1. Remove the oil seal from the torque converter housing.






2. Remove the mainshaft bearing using the adjustable bearing puller, the bearing remover shaft, and the slide hammer.






3. Install a new bearing until it bottoms in the torque converter housing using the driver handle and the 62 x 68 mm bearing driver attachment.






4. Install a new oil seal flush with the torque converter housing using the driver handle and the 72 x 75 mm bearing driver attachment.

NOTE: Do not drive the oil seal into the torque converter housing until it bottoms out, it will block the fluid return passage and cause transmission damage.