Power Rear Window Sunshade Control Unit Input Test

Power Rear Window Sunshade Control Unit Input Test

1. Remove the rear shelf under cover Service and Repair.

2. Disconnect the 5P connector (A) from the power rear window sunshade control unit (B).





3. Inspect the connector and socket terminals to be sure they are all making good contact.

- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 4.

4. Reconnect the connector to the control unit, and do the following input tests.

- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace the power rear window sunshade.