Manufacturer Code Charts: 2608

Navigation System DTC Troubleshooting: 1701, 2608

DTC 1701:

R- Camera Error

DTC 2608:

R- Camera Diag

NOTE:

- Check the vehicle battery condition first Testing and Inspection.
- These navigation DTCs sets when a mechanical malfunction in the navigation display is detected. set when a communication error between the rearview camera and the navigation display unit (open or short) is detected.
- Before you troubleshoot, make sure to follow the General Troubleshooting Information How to Troubleshoot the Navigation System.

1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, then back to ON (II), or the ON mode.

2. Go into the System Diagnostic Mode, and select the Self-Diagnosis Mode in the Select Diagnosis Items menu Navigation System Diagnostic Mode.

3. Check the System Links.

Is the R- camera icon red?

YES -

Go to step 4.

NO -

Intermittent failure, the system is OK at this time.�

4. Check for poor connection or loose terminal at the rearview camera 12P connector.

Are the connections OK?

YES -

Go to step 5.

NO -

Repair poor connection or loose terminal.�

5. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

6. Disconnect the rearview camera 12P connector.

7. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

8. Measure the voltage between rearview camera 12P connector terminal No. 7 and body ground.





Is there about 3.0 V?

YES -

Replace the rearview camera Service and Repair.�

NO -

Go to step 9.

9. Measure the voltage between navigation display unit 32P connector terminal No. 22 and body ground.





Is there about 3.0 V?

YES -

Repair an open in the wire between the navigation display unit and the rearview camera.�

NO -

Replace the navigation display unit Service and Repair.�